HONDA 2003 Accord Coupe - Owner's Manual - Manual (Page 325)

Torque the spark plug. (If you do
not have a torque wrench, tighten
the spark plug two-thirds of a turn
after it contacts the cylinder head.)
Tightening torque: Put the new spark plug into the
socket, then screw it into the hole.
Screw it in by hand so you do not
crossthread it. Use a wrench to remove the
hexagon socket head cap bolt
holding the ignition coil. Remove
the ignition coil by pulling it
straight out.
Remove the spark plug with
a five-eighths inch (16 mm) spark
plug socket.
6. 7. 4.
5.
Spark Plugs (6-cylinder Models)
Maintenance 322
HEXAGON SOCKET HEAD CAP BOLT
13 lbf·ft (18 N·m , 1.8 kgf·m)
Main Menu Table of Content