HONDA 2003 Accord Coupe - Owner's Manual - Manual (Page 79)

With the headlight switch off, the
high beam headlights and the high
beam indicator come on with
reduced brightness when you turn
the ignition switch to ON (II) and
release the parking brake. They
remain on until you turn the ignition
off, even if you set the parking brake.
The headlights revert to normal
operation when you turn them on
with the switch.
The Select/Reset knob on the
instrument panel controls the
brightness of the instrument panel
lights. Turn the knob to adjust the
brightness.
The instrument panel will illuminate
with reduced brightness when you
unlock and open the driver’s door.
The brightness will increase slightly
when you insert the key in the
ignition switch, then go to normal
brightness when you turn the
ignition switch to ON (II).
If you do not insert the key in the
ignition switch after opening the
driver’s door, the illumination turns
off in about 30 seconds after closing
that door.
If you insert the key but do not turn
the ignition switch to ON (II), the
illumination turns off in about 10
seconds.
To reduce glare at night, the instru-
ment panel illumination dims when
you turn the light switch to
or
. Turning the Select/Reset
knob fully to the right until you hear
a click will cancel the reduced bright-
ness.
Instrument Panel Brightness Daytime Running Lights
(Canadian Models)
Controls Near the Steering Wheel
Instruments and Controls 76
SELECT/RESET KNOB
Main Menu Table of Content