CatEye EC-3600 - Manual (Page 24)

Cateye Ergociser Series 1000 Service Manual
22
EC-1200 EC-1600 EC-3600 EC-3700 Applicable Models:
D-1
D-1
ON
OFF
ON
OFF
Fig. 1
Leg Pipe Fixing Screw
No. 15 Wrench
ON
OFF
Frame Cover
Removing the Frame Covers
Upright Type (EC-1200 & EC-1600)
When any repair or adjustment of parts within the frame is required,
remove the frame covers in the following procedures.
REMOVAL
1. Remove the pedals at both the left and right sides. (The right
side pedal can be removed by turning it in the clockwise
direction, and the left side pedal can be removed in the
counter-clockwise direction.) (Fig. 1)
2. Remove the crank cover fixing screws. The narrow-width area
of the crank cover should be positioned in between the frame
cover and the crank. (Fig. 2)
3. Remove the leg pipe fixing screws. (Fig. 3)
* You do not have to remove the leg pipe itself.
* For the model EC-1600, remove the leg pipe cover.
4. Shift the rubber base at the seat post lock knob away from the
center cover.
5. Loosen the center cover fixing screw a little, and lift the center
cover upward. (Do not remove it.) (Fig. 4)
6. Loosen the four screws on the inlet cover. (Fig. 5)
7. Remove the frame cover fixing screw with a screwdriver before
removing the frame cover. (Fig. 6)
ASSEMBLING
1. Place the frame covers onto the frame at both right and left
sides, paying attention to the position of the crank.
2. Fix the right and left frame covers with frame cover fixing
screws.
3. Mount the inlet cover with four screws. (Fig. 5)
4. Set the center cover to the frame cover correctly in position,
and fix it with the center cover fixing screws. (Fig. 4)
5. Pass the crank through the hole on the crank cover, and fix the
crank cover onto the frame cover with screws. (Fig. 2)
6. Set the rubber base for the seat post lock knob, and then
mount the right and left pedals.
7. Fix the leg pipe with the leg pipe fixing screws. (For the model
EC-1600, mount the leg pipe cover.)
Fig. 2
Fig. 3 Fig. 4
Fig. 5 Fig. 6
Crank
Pedal
Crank Cover
Front Rear
Leg Pipe Fixing Screw
Center Cover Fixing Screw
Lift upward.
Center Cover
Inlet Cover
Four (4)
Screws
Removing the Frame Covers