CatEye EC-3600 - Manual (Page 60)

Cateye Ergociser Series 1000 Service Manual
58
EC-1200 EC-1600 EC-3600 EC-3700 Applicable Models:
Replacing the Handlebar Grip
MS-21
MS-21
Replacing the Handlebar Grip
1. In case the handlebar grip is damaged, cut the grip with a thin
cutting knife and peel it off the handlebar.(Fig. 1)
2. Fit a brandnew handlebar grip onto the handlebar, utilizing
compressed air from a compressor, etc. Press the grip into the
handlebar while applying compressed air at one end.(Fig. 2)
* When a compressor is not available, apply a soap water on
the handlebar, and insert the grip while twisting and
pressing the grip.
* When the above replacing work is difficult to achieve,
remove the handlebar before the work.
Existing Grip(Old)
Fig.1
Brandnew Grip
Fig.2
Handlebar
Air Gun,etc