CatEye EC-3600 - Manual (Page 27)

Cateye Ergociser Series 1000 Service Manual
25
EC-1200 EC-1600 EC-3600 EC-3700 Applicable Models:
ES-2
ES-2
Fig. 1
EC-1200
Fig. 2 Fig. 3
EC-1200
Fig. 4
EC-1600
Fig. 5 Fig. 6
Fig. 7
Screws
Replacing the 5P Cable (1)
Procedures are different depending on the type of model as shown
below:
Upright Type (EC-1200)
Removing the Existing Cable
1. Loosen the four screws which fix the control unit to remove the
control unit. Also, remove the cable connector. (Fig. 1)
2. Remove the cable holder which fixes the 5P cable to the
handlebar post.
3. Remove the frame cover. (See the Section D-1 "Removing the
Frame Covers.")
4. Remove the CN-2 connector from the power supply board.
(Fig. 2)
5. Cut the cable holders which fix the 5P cable to the frame, and
remove the 5P cable.
Mounting the Brand New Cable
1. Mark the 5P cable at a point approx. 87cm from the unit-side
cable connector (Fig. 3), and connect the leading end of the
CN-2 connector to the power supply board.
2. (1)Using cable holders, fix the 5P cable at the bottom of the
handlaber pipe of the main unit frame.(2)Fix the cable at the
marked point of the cable to the handlebar pipe just beneath
the horizontal frame.(3)Pass the 5P cable along with the
handlebar pipe, and the sagging portion should be binded with
a cable holder. (Fig. 4)
3. Connect the cable connector to the control unit, and apply the
connector cover.Then, fix the control unit to the handlebar post
by using four screws. (Fig. 1)
4. Provisionally turn on the power, and check if the control unit
works fine.
5. Fix the 5P connector to the handlebar post with the cable
holder.
6. Mount the frame cover. (See the Section D-1 "Removing the
Frame Covers.")
Upright Type (EC-1600)
Removing the Existing Cable
5P Cable Handleber Post
1. Loosen the four screws which fix the control unit to remove the
control unit. Also, remove the cable connector. (Fig. 4) Slide
the inner handlebar post cover upward, and unplug the cable
connector. (Fig. 5)
2. Remove the screws of both the handlebar stem and the outer
handlebar post cover to remove the 5P cable. (Fig. 6)
5P Cable within the Frame
1. Remove the frame cover. (See the Section D-1 "Removing the
Frame Covers.")
2. Remove the CN-2 connector at the end of the 5P cable from
the power supply board.
3. Cut the cable holders which fix the 5P cable to the handlebar
pipe, and remove the 5P cable.
To be continued on the next page.
Fig. 8
Cable
Connector
Power Supply Board Unit-Side Cable Connector
Mark this point.
87cm
Handlebar Pipe
Horizontal Frame
Cable Holders
(1)
(2)
(3)
Cable
Connector
Screws
Unplug
Inner Handlebar Post Cover
Screws
Handlebar Stem
Cover
Cable Connector
Cable Holder
5cm
Replacing the 5P Cable (1)