Interlogix NX-4V2 User Manual - Manual (Page 10)

6 NX-4V2 LED Keypad User Manual
Emergency activation keys
Figure 1: Emergency activation keys
Note: You must hold these keys for 2 seconds to activate these functions. Your
system may not be programmed for these activation keys. You should press
these keys only in an emergency situation that requires response by emergency
personnel. If your system is programmed for these functions, the following
reports can be sent.
Fire Key – This key can activate the fire alarm when pressed for two seconds. If
your system is connected to a monitoring center, an emergency report could be
sent to that center.
Auxiliary Emergency Key
– This key can activate the auxiliary alarm when
pressed for two seconds. If your system is connected to a monitoring center, an
emergency report could be sent to that center.
Police (Panic/Hold-Up) Key - This key can sound a local audible alarm when
pressed for two seconds. If your system is connected to a monitoring center, an
emergency report could be transmitted to that center. Note: Some Panic/Hold-Up
alarms are programmed to be silent at the protected site while reporting an alarm
to the monitoring center. Check with your installing company to determine how
your security system will respond to the Panic/Hold-Up activation.
Keypad functions
Arming your system in the “AWAY” mode
AWAY is used when the user is away from the premise and wants the interior
protected. Listed below are the steps to arm in the AWAY Mode:
Step 1 Close all protected doors and windows.
• Ready light will be on or flashing when all protected zones and sensors are
secure. Note: If any zones are bypassed, a sensor in that zone can be
violated without affecting the ready light.
• The security system will not arm if the ready light is not on or flashing.
• If the power light is off, you have no AC power. Restore power if possible. If
not, contact your installing company for service.