Interlogix NX-4V2 User Manual - Manual (Page 14)

10 NX-4V2 LED Keypad User Manual
Adding and changing user codes
Your system must be Disarmed to add/change user codes.
1. Press [*]-[5].
2.
Enter a “Master Arm/Disarm Code”.
3. The ready light will flash.
4. Enter the 2 digit. Always enter 2 digit such as [0] - [3] for user 3,.
5.
Enter the new four (4) or six (6) digit “user code”. Note: To delete a user
code, enter [r]-[r]-[r]-[r] for a 4-digit code, or [r]-[r]-[r]-[r]-[r]-[r] for a 6-digit code.
6. The ready light will flash indicating you are back at Step 4 above. If the code
is rejected, the sounder will beep 3 times.
NOTE: To delete a user code, enter [
∗
]-[
∗
]-[
∗
]-[
∗
] for a 4-digit code, or [
∗
]-[
∗
]-
[
∗
]-[
∗
]-[
∗
]-[
∗
] for a 6-digit code.
7. The ready light will flash indicating you are back at Step 4 above. If the code
is rejected, the sounder will beep 3 times.
8. If another “user code” needs to be programmed, return to Step 5.
9. Press the [#] key while the ready light is flashing to exit the User Code
Programming Mode.