Interlogix NX-4V2 User Manual - Manual (Page 12)

8 NX-4V2 LED Keypad User Manual
Using the Quick Arm (optional)
The Quick Arm feature may be used if it is enabled. Quick Arm will allow the user
to arm the security system without entering a user code. Quick Arm in the AWAY
mode is possible by pressing the [EXIT] key. The system can be quick armed in
the STAY mode by pressing the [STAY] key. This feature is used for ARMING
ONLY, and will not disarm the security system. This is ideal for a maid or baby
sitter code, etc.
Changing modes while system armed
1. Pressing the [STAY] key will turn on/off (toggle) a delay on Entry/Exit doors
and turn on/off (toggle) the instant light.
2. Press the [BYPASS] key at this time to turn on/off (toggle) all designated
interior zones. This is only possible if programmed by your installer
(“bypass toggle” option set).
3. When armed, pressing the [EXIT] key will start the Exit delay, enabling you to
leave the building. This is only possible if programmed by your installer
(“re-exit” option set).
Important: The instant light needs to be off at this time if you plan on re-entering
the building, otherwise you can create an alarm. You may re-initiate an exit/entry
delay by pressing the [STAY] key again. The instant light will go out.
Disarming the system
When you enter the protected area through one of the designated Entry/Exit
doors, the keypad control will sound a solid tone for the duration of the entry
delay time, or until you enter a valid code. After entering a valid code, the red
armed light will go off and the tone will stop. The security system is now
DISARMED. If a valid code is not entered before the end of the entry delay, an
alarm will occur.
Note: If the red armed light is flashing during the entry delay, the alarm system
has been activated in your absence. Leave the building immediately and call your
alarm company and/or the police from a safe location.
CANCEL / ABORT feature (optional)
The cancel light will flash during an abort delay time. If a code is entered followed
by the [CANCEL] key while this light is flashing, all abortable reports will stop the
communication process. Note: The abort feature must be enabled. Entering a
code followed by the [CANCEL] key during or after an alarm report to the central