Interlogix NX-6V2 User Manual - Manual (Page 11)

9
CANCEL / ABORT FEATURE (Optional, see page 1)
The cancel light will flash during an abort delay time. If a code is entered
followed by the [CANCEL] key while this light is flas hing, all abortable reports
will stop the communication process. Entering a code followed by the [CANCEL]
key during or after an alarm report to the central station will cause the cancel
light to come on. It will stay on until the central station has recei ved the cancel
report. No additional keypad tones will be emitted.
BYPASSING ZONES
If you wish to bypass one or more zones, this must be done while the system is
in the disarmed state. The following steps are used for bypassing zones:
Step 1 Press the [BYPASS] key.
Step 2
Enter user code if required (optional). The b ypass light flashes.
Step 3
Enter the digits indicating the zone you wish to bypass. (Example:
Press the [1] key for zone 1, press [1] - [2] for zone 12.)
Step 4
Press the [BYPASS] key again.
Step 5
The corresponding zone light will illuminate indicating the zone
has been bypassed. Repeat steps 3 and 4 for any other zone(s)
that need to be bypassed.
Step 6
Press the [BYPASS] key again -or- press the [#] key to exit the
Bypass Mode. The b ypass light will stop flashing upon exiting the
Bypass Mode.
GROUP BYPASS
By pressing the [BYPASS] key, followed by the [0] key, then the [BYPASS] key
again, all zones that are designated as group bypas s zones will be bypassed.
Press the [BYPASS] key again to exit group bypassing.
UNBYPASSING
To manually unbypass zones, perform the bypassing procedure on a zone that
is already bypassed. The corresponding light for that zone will go off when
unbypassed. NOTE: All zones will automatically be unbypassed each time the
system is disarmed.
TURNING THE DOOR CHIME ON AND OFF
The door chime is turned on or off by pressing the [CHIME] key while the system
is in the disarmed state. If the chime is on the chime light will be illuminated. If
the chime is off, the chime light will be off. Each press of the [CHIME] key will
toggle the chime feature on/off and produce a momentary ding -dong sound.