Interlogix NX-6V2 User Manual - Manual (Page 15)

13
zone(s) will be displayed on the LCD keypad. It will also be
entered into alarm memory and the internal log.
Step 3 The keypad will begin to beep after 15 minutes in this mode. This
beeping indicates that the
“Walk-Test” mode will be automatically
exited in 5 minutes.
Step 4 To exit at any time during this mode, enter a user code. Otherwise
the AWalk-Test Mode@ will automatically exit after 20 minutes.
RESET FUNCTION
This function is used to reset Smoke D etectors, Zone Troubles, and Zone
Tampers.
Step 1 Disarm the system if not disarmed.
Step 2 Press [

]-[7]. Resets have now been performed.
Step 3 If the keypad begins beeping, the reset did not execute properly.
Enter your code to silence the keypad. Wait a few minutes and
repeat step 2 to attempt another reset. If the keypad still beeps after
repeated attempts, please contact your installer.
SET SYSTEM DATE
Step 1 Press the [

]-[9]-[6].
Step 2 Enter th
e “Master Code”.
Step 3
Enter the “Day of Week “
1 = Sunday
3 = Tuesday 5 = Thursday 7 = Saturday
2 = Monday 4 = Wednesday 6 = Friday
Step 4
Enter the “Month Code”. Must always be two (2) digits.
01 = January
05 = May 09 = September
02 = February 06 = June 10 = October
03 = March 07 = July 11 = November
04 = April 08 = August 12 = December
Step 5
Enter the “Day Code”. Must always be two (2) digits.
Example: The 5
th
would be entered as [0]
–[5].
Step 6
Enter the last two digits of the “Year Code”.
Example: For 2007 enter [0]
–[7].
SETTING THE SYSTEM CLOCK
Step 1 Press [

]-[9]-[7].
Step 2
Enter the “Master Code “.
Step 3
Enter the “hour code” which must be two (2) digits. Note: The
clock is a 24-hour clock. Refer to the following table on page 14.
Step 4
Enter the “minutes code” which must be two (2) digits.
Example: 7 minutes after would be entered [0]
–[7].