Emergency activation keys – Interlogix NX-6V2 User Manual User Manual

Page 8

Advertising
background image

6

Ready Light

The ready light

is “on” when the system is ready to arm and “flashes” if ready

to force arm. The ready light is off when the system is not ready to arm
because of a zone(s) being faulted.

Stay Light

The stay light is

“on” when the all interior (motion detector) zones are

bypassed.

Zone Light

The zone lights

are “off” when everything is normal. A zone light will be “on” if

the zone has been bypassed. If a zone light

is “flashing”, that zone is in alarm

or has been faulted. If a zone light

is “flashing” rapidly, it means that the zone

is in a trouble condition. Trouble conditions are:

Tamper

Hardware

Low Battery

Loss of Supervision

(A combination of Alarm/Fault and Tamper/Trouble will produce a rapid
“flashing” light for a short period of time, followed by a slow “flashing” light.)


EMERGENCY ACTIVATION KEYS

NOTES: You must hold these keys for 2 seconds to activate these
functions. Your system may not be programmed for these activation keys
(see page 1)
. You should press these keys only in an emergency situation that
requires response by emergency personnel. If your system is programmed for
these functions, the following reports can be sent.

Fire Key

– This key can activate the fire alarm when pressed for 2 seconds. If

your system is connected to a monitoring center, an emergency report could be
sent to that center. The keypads sound a continuous beeping.

Auxiliary Emergency Key

– This key can activate the auxiliary alarm when

pressed for 2 seconds. If your system is connected to a monitoring center, an
emergency report could be sent to that center. The keypads sound a
continuous beeping.

Police (Panic/Hold-Up) Key
- This key can sound a local audible alarm when
pressed for 2 seconds. If your system is connected to a monitoring center, an
emergency report could be transmitted to that center. NOTE: Some Panic/Hold-
Up alarms are programmed to be silent at the protected site while reporting an
alarm to the monitoring center. Check with your installing company to
determine how your security system will respond to the Panic/Hold -Up
activation. If programmed for Silent Hold-up, the keypads will not sound.
Otherwise, the keypads will sound a continuous beeping.

Advertising