Interlogix NX-6V2 User Manual - Manual (Page 16)

14
Time Hour Code Time Hour Code Time Hour Code
12:00
Midnight
00 8:00 AM 08 4:00 PM 16
1:00 AM 01
9:00 AM
09
5:00 PM
17
2:00 AM 02
10:00 AM
10
6:00 PM
18
3:00 AM 03
11:00 AM
11
7:00 PM
19
4:00 AM 04
12:00
Noon
12 8:00 PM 20
5:00 AM 05
1:00 PM
13
9:00 PM
21
6:00 AM 06
2:00 PM
14
10:00 PM
22
7:00 AM 07
3:00 PM
15
11:00 PM
23
KEYPAD CONTROL TONES (BEEPS)
A sounder is built into the keypad. If programmed, your system keypad may
sound for any of the following reasons:

Beeps for all keypresses.
 Sounds a continuous tone during the Entry delay time.

Pulses when a day zone is violated while the system is disarmed.

Pulses when a FIRE zone has a trouble condition.
 Beeps 3 times for trying to arm with the “Ready” light off, if “Force Arming”
has not been selected.
 Beeps for 1 second or emits a “ding-dong” sound for the “Chime” feature.

Beeps during an exit delay; beeps rapidly for the last 10 seconds of an exit
delay; and beeps 1 second at the end of the exit delay.

Pulses when the armed status changes and the AC power is off.

Pulses when the armed status changes and any zone(s) are bypassed.

Pulses when the armed status changes and a low battery is detected.

Pulses when the armed status changes and a Tamper condition is
detected.

Beeps to indicate Telephone Line Cut, if selected.

Pulses when one or more of the following conditions are detected: Zone or
Box Tamper, Low Battery, AC Power Fail, or Expander trouble.

Beeps 3 times every minute indicating a low battery or missing transmitter
is detected (if wireless device is in system). Entering code will suppress
the sounder for 12 hours.
Entering a valid code will silence the keypad sounder when it is pulsing. The
arm/disarm state of your system will not change when entering a code to
silence a pulsing keypad sounder. Please contact your installer if a trouble
condition exists.