Interlogix NX-6V2 REV B Installation Manual - Manual (Page 7)

• Total current draw from auxiliary power connections at
terminal positions POS, AUX PWR, and SMOKE PWR
must not exceed 400 mA.
• Remote downloading must not be used on UL listed
systems.
• For residential burglary applications, the maximum entry
and exit delay times are 45 and 60 seconds respectively.
The exit delay time must not exceed 60 seconds for
commercial burglar alarm applications.
• The keyswitch option must not be used.
• The telephone line monitor must be enabled.
• The telephone line cut delay must not exceed 90 seconds.
• The 24-hour communicator test transmission is required.
• For 24-hours of standby power using a 7.0 Ah battery, limit
auxiliary power load to 140 mA.
• For 24-hours of standby power using a 17.2 Ah battery,
limit auxiliary power load to 400 mA.
• The silent keypad option must not be enabled.
• UL has only verified compatibility with the following listed
DACRs and formats: Sure-Gard SG-MLR2-DG:
2,9,10,12,13,14; Silent Knight 9000 - 2,12; FBI -
CP220FBI, 13; and Ademco 685: 2,11,12, and 13.
• For burglary installations, cross zoned detectors must
overlap 100 percent in the area of coverage, and similar
coverage areas must be used. For example, interior
protection is cross zoned with interior protection, and so
on.
• Expander trouble must activate the siren.
• For UL 1637, expander trouble must activate the keypad
sounder.
• If the late to close/early to open feature is enabled, the
opening and closing reports must be enabled.
• For Canadian installations, the class II transformer secure
tab must not be employed.
• The four-wire smoke detector employed must be rated to
operate over the voltage range of 11.5 to 12.4 V.
• Compatible listed devices: (special applications):
• Bell output (sirens): Wheelock models: NS-1215W,
NS- 121575W, NS4-1215W, NS4-121575W, AS-1215W,
AS- 121575W
• Horn/strobe system sensor: S1224MC strobe series;
1224MC Horn/strobe series; H12/24 Horn series
• Smoke output (four-wire detectors): ESL: 500N
series; 449CTE series; 521 series; 541 series
• System sensor models: 2112/24R; 2112/24TR;
2112/24AT; 2112/ATR; 2112/24AITR; 4WTA-B;
4WTR-B; 4WTAR-B; 4WITAR-B
• Detection systems: F220-B6C; D273 series; Hochiki:
SBC- 4/12, 4/12W
Additional UL 609 installation requirements
The alarm housing for a mercantile alarm system without a
remote alarm transmission connection shall be mounted on the
outside of the building, visible from a public street or highway.
It shall be accessible for examination and repair. It shall also
be located not more than four stories above the street level
unless:
a) A second alarm sounding device and housing, intended for
outside service is mounted adjacent to the premises or area of
the building in which the alarm system is installed or
b) A second alarm sounding device, intended for inside service
is mounted within the premises.
In either case, the outside alarm sounding device and housing
may be mounted as high as the seventh floor.
Additional UL 365 installation requirements
In a mercantile burglar alarm system, a mercantile alarm
sounding device located within a building, but outside the
protected area, is acceptable, provided it is rated for outside
service and alarm conditions are transmitted to:
a) The dispatch location of the law enforcement agency having
jurisdiction over the protected property or
b) A central station or residential monitoring station complying
with the Standard for Central-Station Alarm Services, UL 827.
In a mercantile burglar alarm system, an alarm sounding
device located within the area of greatest protection, or outside
the area of greatest protection but within an area protected by
an alarm system and that shares a common control unit with
the system installed in the area of greatest protection, is
acceptable provided it is rated for inside service and alarm
conditions are transmitted to:
a) The dispatch location of the law enforcement agency having
jurisdiction over the protected property or
b) A central station or residential monitoring station complying
with the Standard for Central-Station Alarm Services, UL 827.
An inside sounding device shall be mounted at least 10 feet
(3.05 m) above the floor or at the surface of the ceiling. When
there is fixed construction within the area that could provide
access for an intruder, the alarm sounding device shall also be
mounted at least 4 feet (1.2 m), as measured horizontally,
away from the edges of the fixed construction or at least 10
feet (3.05 m) above it so as to minimize access by an intruder.
NX-6V2 Control Panel Installation Instructions 7