Interlogix TVE Series - Manual (Page 16)

12 TVE-400/800-1600 H.264 IP Video Encoder User Manual
Figure 7: PTZ control
Directional buttons: Control the pan and tilt movement
Control the lens:
Adjust the zoom in/out
Adjust the focus near/far
Adjust the iris open/close
Adjust the speed of the pan and
tilt movement Turn on/off the camera light and wiper
Connecting the PTZ camera to the encoder
Ensure that the PTZ dome cameras are correctly connected to the RS-485 port
on the encoder back panel. Connect the R- and R+ terminals of the PTZ camera
or speed dome to the RS-485 T- and RS-485 T+ terminals respectively.
Configure the RS-485 parameters under the Configuration > Serial port
settings > 485 serial port menu. See page 32.
Presets
Presets are previously defined locations of a PTZ dome camera. It allows you to
quickly move the PTZ dome camera to a desired position. Up to 256 preset can
be configured.
To set up a preset:
1. In live view mode, select a preset from the preset list.
2. Use the directional, zoom, focus and iris buttons to position the camera in the
desired preset location.
3. Click to save the position.