Interlogix DVR 41 User Manual - Manual (Page 130)

12BChapter 13: HDD management
124 TruVision DVR 41 User Manual
4. Click the Edit icon . The Local HDD Settings screen appears.
5. Click the desired HDD property for the selected HDD.
6. Click the group number for this HDD.
7. Click Apply to save and exit the screen.
Note: Once set to read-only, the HDD cannot be used to save recorded files
until it is set back to read/write (R/W). If the HDD that is currently being
written to is set to read-only, the data is then recorded to the next HDD. If
there is only one HDD present, setting it to read-only means the DVR cannot
record.
Checking HDD status
You can check the status of any of the installed HDDs on the DVR at anytime.
To check the status of a HDD:
1. Click the System Settings icon in the menu toolbar and then click Hard Disk .
2. Note the status of the HDDs listed under the Status column.
If the status is listed as Normal or Sleeping, the HDD is in working order. If it
is listed as Abnormal and has already been initialized, the HDD needs to be
replaced. If the HDD is Uninitialized, you need to initialize it before it can be
used in the DVR. Refer to “Initializing HDDs” on page 121 for more
information.
Note: This information is also available under System Settings > System
Information > HDD screen.
Configuring HDD alarms
HDD alarms can be set to trigger when an HDD is uninitialized or in an abnormal
state.
To set HDD alarms:
1. Click the Alarm settings icon in the menu toolbar and select Notification .
2. Select the notification event to configure under Notification Type box.
3. Select HDD Full and check the desired notification method. See “Description
of alarm notification types” on page 97 for more information.
Select HDD Error and check the desired notification method.
4. Click Apply to save the settings.