Interlogix DVR 41 User Manual - Manual (Page 44)

4BChapter 5: Live view
38 TruVision DVR 41 User Manual
depending on the dwell time set up. You can set up different dwell time for
alarms and events.
To set the camera sequencing for alarms and events:
1. Click the Display Mode Settings icon in the menu toolbar.
2. Select Layout > General .
3. From Event Output , select the desired monitor from the drop-down list.
Default is VGA, if connected
4. Select the dwell times for the alarm and event cameras. Default is 10
seconds. The dwell time can range between 10 and 300 seconds.
5. Click Apply .
Configuring time and date
You can set up the date and time that will appear on-screen. It is not included in
recordings. This time and date display is separate from the embedded one that
appears for each camera (see “Configuring the camera OSD settings” on page
129 for more information on embedded camera time and date).
The start and end time of daylight savings time (DST) in the year can also be set.
DST is deactivated by default. See Figure 18 below for the Time settings screen.
Figure 18: Time and date settings screen