Canon FS 3.6 - Manual (Page 107)

107
Copying with CanoCraft FS Copy
Adjusting CanoCraft FS Copy Settings
The scanner and printer settings used by CanoCraft FS Copy are automatically set
when you install CanoCraft FS or change configurations. Although there is no need
to adjust the scanner or printer settings for CanoCraft FS Copy under normal
operating conditions, you may wish to change them to accommodate changes in
the printer paper size or orientation, or when using more than one scanner or
printer.
• To change settings, ensure that the scanner and printer are correctly
connected and turned on, then turn on the computer and start Windows.
Changing the Printer Settings
Specify the printer by clicking the printer selection button to the right
in the printer area and selecting a printer from the pull-down menu.
Click the [Setup] button on the left of the printer area and set the
paper size, orientation and source settings.
Clicking the [Properties] button will display the properties dialog for the
selected printer.
Click the [OK] button once you are satisfied with the settings.
Printers registered with Windows will display
in the pull-down menu.
Click this button to adjust the detailed
settings for the printer. Refer to the manual
accompanying your printer for an explana-
tion of the settings.