Canon FS 3.6 - Manual (Page 81)

81
Other Functions
Selecting the Scanner
CanoCraft FS works with both CanoScan FS2710 and CanoScan 2700F film scanners.
Use the following procedures to switch between models if required.
• The scanner attached to the computer will automatically be selected when
CanoCraft FS is installed or auto configuration is run. Accordingly, you need
only perform this procedure when you simultaneously use more than one
scanner and switch between them or when you wish to confirm the name
of the attached scanner.
• This function cannot be accessed when CanoCraft FS is started as a TWAIN
Driver from a TWAIN-compliant application. To select a scanner in this case,
use the application program’s scanner selection function.
Scanner Selection Dialog
This dialog allows you to select between different scanner models.
Scanner Selection Dialog
Click the [Device] menu and select [Select].
Click the button on the right to display the names of
the scanners that can be selected (the attached scanner is
usually the only name available).
Click the name of the desired scanner to select it and click
the [OK] button.
Clicking the [Cancel] button returns the selection to its
prior setting and closes the dialog.