Keri Systems EntraGuard Bronze Quick Start - Manual (Page 11)

EntraGuard Bronze
1530 Old Oakland Road, Suite 100 01911-001 Rev. J
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 11 of 32
Telephone Entry
Quick S
tart Guide
3.2 Call Waiting
If a visitor attempts to notify the residence and the residence telephone is busy, the EntraGuard
Bronze generates a call waiting signal consisting of two, short, high-pitched beeps at three-second
intervals.
1. To put the original call on hold and respond to the EntraGuard Bronze unit, the residence
telephone user presses the key.
2. Once the connection to the EntraGuard Bronze is ended, the residence telephone automatically
reconnects to the call on hold.
3.3 Call Forwarding
If the Call Forwarding feature is enabled, the EntraGuard Bronze dials a programmed remote
telephone number instead of the residence telephone. If the remote number is busy, the EntraGuard
Bronze unit disconnects immediately.
3.4 Remote Connection
Remote Connection allows you to program the EntraGuard Bronze unit from the residence
telephone.
1. The residence telephone can connect to the EntraGuard Bronze at any time by pressing the
key three times with a brief delay between key presses.
2. Once connected, you must enter programming mode (see Section 5.1 on page 14) and then you
can begin programming the EntraGuard Bronze unit.
3.5 Gate Operation From The EntraGuard Bronze Unit
The Gate Operation from the EntraGuard Bronze Unit command allows you to immediately open a
gate from the Bronze unit.
• To open Gate 1 from the EntraGuard Bronze unit, press , press , and press the user’s
three-digit entry code.
• To open Gate 2 from the EntraGuard Bronze unit, press , press , and press the user’s
three-digit entry code.
• If a code entry mistake is made, the user can cancel the entry by pressing the key at any
time.
EXAMPLE: Enter the following to open Gate 1 from the EntraGuard Bronze unit with a user entry
code of “212.”