Keri Systems EntraGuard Bronze Quick Start - Manual (Page 5)

EntraGuard Bronze
1530 Old Oakland Road, Suite 100 01911-001 Rev. J
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 5 of 32
Telephone Entry
Quick S
tart Guide
2.2.3 Phone Line
The EntraGuard Bronze does not require a separate control unit or second phone line. It is wired in
series with the incoming telephone service (Figure 3 on page 5). Using standard two-conductor
telephone cable and RJ-11 plugs, connect the incoming phone service to the J1-CO jack (Central
Office) on the EntraGuard Bronze PCB (see Figure 2 on page 3). Then connect the residential
phone system to the J3-Phone jack.
In applications where the residential phone system has multiple phone lines, only one incoming
telephone line can be designated as the telephone entry line, run through the EntraGuard Bronze
unit.
NOTE: Telephone wiring must be done to telephone industry standards to ensure the TIP and Ring
lines are correctly connected. If these lines are not correctly connected, the unit will not operate
properly.
Figure 3: In-Series Telephone Line Routing