Keri Systems EntraGuard Bronze Quick Start - Manual (Page 22)

EntraGuard Bronze
1530 Old Oakland Road, Suite 100 01911-001 Rev. J
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 22 of 32
Quick S
tart Guide
Telephone Entry
5.3.13 Enable Call Forwarding
The Enable Call Forwarding command allows you to enable the EntraGuard Bronze unit to perform
call forwarding. A call forwarding telephone number must have already been programmed into the
EntraGuard Bronze unit (see “Set Call Forwarding Phone Number”). Typically this command is
used when you will not be in the residence, but you still need to be able to grant access to a visitor.
When this feature is activated and a visitor requests entry, the EntraGuard Bronze will dial the call
forwarding telephone number instead of the residence telephone number. Perform the following to
enable call forwarding.
1. Press . If a call forwarding telephone number has not already been entered an error
tone sounds and the input is ignored.
2. Press to enable call forwarding. The unit emits a short, high-pitched tone followed by a
low-pitched tone to indicate call forwarding has been enabled.
EXAMPLE: Enter the following to Enable Call Forwarding.
3. You can now enter another program command or press to exit programming mode.
5.3.14 Disable Call Forwarding
The Disable Call Forwarding command allows you to disable the EntraGuard Bronze unit to
perform call forwarding. Perform the following to disable call forwarding.
1. Press . If a call forwarding telephone number has not already been entered an error
tone sounds and the input is ignored.
2. Press to disable call forwarding. The unit emits a short, high-pitched tone followed by a
low-pitched tone to indicate the call forwarding has been disabled.
EXAMPLE: Enter the following to Disable Call Forwarding.
3. You can now enter another program command or press to exit programming mode.