Keri Systems EntraGuard Bronze Quick Start - Manual (Page 26)

EntraGuard Bronze
1530 Old Oakland Road, Suite 100 01911-001 Rev. J
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 26 of 32
Quick S
tart Guide
Telephone Entry
5.3.19 Close Gate 2
The Close Gate 2 command is used to immediately close a gate. Typically this command is used to
close a gate that has been held-open indefinitely, or to close a gate before its programmed hold-open
time expires. Perform the following to close gate 2 immediately.
1. Press .
2. Press to close gate 2 immediately. The unit emits a short, high-pitched tone to indicate the
close gate 2 command has been accepted. The unit emits a short, high-pitched tone followed by
a low-pitched tone if the gate 2 hold-open time has been rejected.
EXAMPLE: Enter the following to close gate 2 immediately.
3. You can now enter another program command or press to exit programming mode.