Vermont Casting DVR33 - Manual (Page 23)

23
Vermont Castings, Majestic Products: DVR33
10004920
Operating Instructions
Use only glass approved by Vermont
Castings, Majestic Products on this
fireplace.
• The use of any non-approved replacement glass
will void all product warranties.
• Care must be taken to avoid breakage of the glass.
• Under no circumstances should this appliance be
operated without the front glass in place, or with the
glass in a damaged condition.
• Replacement glass (complete with gasket) is
available through your Vermont Castings, Majestic
Products dealer, and should only be installed by a
licensed qualified service person.
Glass Information
Louvre Removal
To remove the louvre assembly top, lift the panel up
and out from the fireplace (Fig. 38).
NOTE: The louvre assembly bottom is hinged at
the bottom edge and swings down.
It is necessary to periodically clean the glass panel.
During start-up, it is normal for condensation to form
on the inside of the panel. This condensation causes
lint, dust and other airborne particles to cling to the
surface of the glass.
Also, initial paint curing may deposit a slight film on the
glass. It is therefore recommended the glass panel be
cleaned two or three times with a non-ammonia-based
household cleaner and warm water within the first few
weeks of operation. We recommend using gas
fireplace glass cleaner.
After the initial cleaning process, clean the glass two or
three times during each operating season, depending
on the environment in the house.
Clean the glass after the first two weeks
of operation.
Do not clean glass when it is hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.
Glass Cleaning
Lower
Clamps
FP1191
Window
Frame
Assembly
Window Frame
Assembly
Fig. 39 Window frame assembly removal.
Pull Clamp Hook
Push Clamp
Handle
1. Turn the fireplace OFF (including the pilot).
2. If the unit has been operating, allow time for the
components to cool.
3. Remove the louvre assembly top.
4. Open the louvre assembly bottom.
5. Release the two clamps along lower edge of the
frame by pulling down on clamp handles (Fig. 39).
Window Frame Assembly Removal
6. Tilt window frame assembly out slightly at the
bottom, lift the frame up and away from the
fireplace.
7. To replace window frame assembly, reverse this
procedure.
1.
2.
Louvre Assembly Top
Window Frame Assembly
FP444
Fig. 38 Remove louvre assembly top.