Vermont Casting DVR33 - Manual (Page 9)

9
Vermont Castings, Majestic Products: DVR33
10004920
Fig. 10 Honeywell Ignition Module.
This appliance may be fitted with a Honeywell
Ignition Module.
To install the remote On/ Off starter switch on
electronic ignition units (Fig. 10):
1. Thread the wiring through the holes on the side
panels of the appliance. Take care not to cut the
wire or insulation on metal edges. Route the wire
to a conveniently located receptacle box.
2. Attach the wire to the On/ Off switch and install
the switch into the receptacle box.
3. Connect the White wire from the wall switch to the
Black wire from the transformer, using an approved
wire nut. Connect the Black wire from the wall
switch to the Black wire running from the #6
position of the ignition module, also using an
approved wire nut.
Electronic Gas Control Valve
PILOT
HONEYWELL IGNITION MODULE
BLUE
BLACK
WHITE
NOVA SIT 822 VALVE
HI
LO
POWER CORD
W/FEMALE SPADE
120 VAC RTN
WHITE
GREEN
BLACK
120 VAC HOT
BLACK
YELLOW
24 VAC RET
40VA TRANSFORMER
24 VAC HOT
BLACK WHITE
WALL SWITCH
WHITE
OFF
1 2 3 4 5 6 8 9
MV MV/VP PV GRD 24V SENSE SPARK
24V
ORANGE
RED
GREEN
ORANGE
General Venting Information
Your fireplace is approved to be vented either through
the side wall, or vertically through the roof.
• Only venting components specifically approved
and labeled for this fireplace may be used.
• Venting terminals shall not be recessed into a wall or
siding.
• Horizontal venting must be installed on a level plane
without any incline or decline.
There must not be any obstruction such as bushes,
garden sheds, fences, decks or utility buildings within
24" from the front of the termination hood.
Do not locate termination hood where excessive snow
or ice build up may occur. Be sure to check vent
termination area after snow falls, and clear to prevent
accidental blockage of venting system. When using
snow blowers, make sure snow is not directed towards
vent termination area.
Location of Vent Termination
It is imperative to observe minimum
clearances (shown on the following
page) when locating vent terminations.
10004083-Fig1