Installation and operating instructions, Vermont castings, majestic products: dvr33, Locating your fireplace – Vermont Casting DVR33 User Manual

Page 3

Advertising
background image

3

Vermont Castings, Majestic Products: DVR33

10004920

This gas appliance should be installed by a qualified installer
in accordance with local building codes and with current CSA-
B149.1
Installation codes for Gas Burning Appliances and
Equipment. If the unit is being installed in a mobile home, the
installation should comply with the current CAN/CSA Z 240.4
code. For U.S.A. Installations follow local codes and/or the
current National Fuel Gas Code. ANSI Z223.1.

FOR SAFE INSTALLATION AND OPERATION
PLEASE NOTE THE FOLLOWING:
1.

This fireplace gives off high temperatures and
should be located out of high traffic areas and away
from furniture and draperies.

2.

Children and adults should be alerted to the hazards
of the high surface temperatures of this fireplace,
and should stay away to avoid burns or ignition of
clothing.

3.

Children should be carefully supervised when in the
same room as your fireplace.

4.

Under no circumstances should this fireplace be
modified. Parts removed for servicing should be
replaced prior to operating this fireplace again.

5.

Installation and any repairs to this fireplace must be
performed by a qualified installer, service agency or
gas supplier. A professional service person should
be contacted to inspect this fireplace annually. Make
it a practice to have all of your gas fireplaces
checked annually. More frequent cleaning may be
required due to excess lint and dust from carpeting,
bedding material, etc.

6.

Control compartments, burners and air passages in
this fireplace should be kept clean and free of dust
and lint. Make sure the gas valve and pilot light are
turned off before you attempt to clean this fireplace.

7.

The venting system (chimney) of this fireplace
should be checked at least once a year and if
needed your venting system should be cleaned.

8.

Keep the area around your fireplace clear of com-
bustible materials, gasoline and other flammable
vapor and liquids. This fireplace should not be used
as a drying rack for clothing, nor should Christmas
stocking or decorations be hung in the area of it.

9.

Under no circumstances should any solid fuels
(wood, coal, paper or cardboard etc.) be used in this
fireplace.

10. The flow of combustion and ventilation air must not

be obstructed in any way.

11. When fireplace is installed directly on carpeting, vinyl

tile or any combustible material other than wood, this
fireplace must be installed on a metal or wood panel
extending the full width and depth of the fireplace.

12. This fireplace requires adequate ventilation and

combustion air to operate properly.

13. This fireplace must not be connected to a chimney

flue serving a separate solid fuel burning fireplace.

14. When the fireplace is not in use it is recommended

that the gas valve be left in the OFF position.

Installation and Operating Instructions

Notes (Fig. 1):

*

When you install your Vermont Castings, Majestic Products fireplace in
(D) Room divider or (E) Flat on wall corner positions, a minimum of (Y),
6 in. (153 mm) clearance must be maintained from the perpendicular
wall and the front side edge of the fireplace.

**

Island (C) and Room Divider (D) installation is possible if the horizontal
portion of the vent system (X) does not exceed 20 ft. (610 cm). See
details in Venting Section.

IMPORTANT: PLEASE READ THE FOLLOWING CAREFULLY

Remove any plastic from trim parts before turning the
fireplace On.
It is normal for fireplaces fabricated of steel to give off some
expansion and/ or contraction noises during the start up or
cool down cycle. Similar noises are found with your furnace
heat exchanger or car engine.
It is not unusual for a Vermont Castings, Majestic Products
gas fireplace to give off some odor the first time it is burned.
This is due to the manufacturing process.

Please open all windows to ensure your room
is well ventilated.

It is recommended that you burn your fireplace for at least
ten (10) hours the first time you use it. If the optional fan kit
has been installed, place the fan switch in the “Off” position
during this time.

Locating Your Fireplace

Fig. 1 Locating Your Gas Fireplace

A) Flat on wall

B) Cross corner

C) Island

**

D) Room divider

*

/

**

E) Flat on wall corner*

F) Chase installation
Y) 6 in. minimum

PROPOSITION 65 WARNING

Fuels used in gas, wood-burning or oil fired appliances,
and the products of combustion of such fuels, contain
chemicals known to the State of California to cause
cancer, birth defects and other reproductive harm.

California Health & Safety Code Sec. 25249.6

LU584-R

Y

E

A

B

C

D

F

Y

B

X

X

This appliance may be installed in an aftermarket,

permanently located, manufactured home, or

mobile home where not prohibited by local codes.

This appliance is only for use with type of gas

indicated on the rating plate. This appliance is

not convertible for use with other gases,

unless a certified kit is used.

Advertising