Longshine LCS-K916 - Manual (Page 11)

10
<Scroll Lock> →<Scroll Lock>→<1>→<Enter> or
<Scroll Lock> →<Scroll Lock>→<2>→<Enter> or
…
…
<Scroll Lock>
→<Scroll Lock>→<16>→<Enter>
Note: You can also select computers in OSD menu. Move the indicator bar to the chanel to switch by using
<arrow key>, <Page Up> or <Page Down>, then press <Enter> to select the connected computer. Please refer
section 7.2 Channel Selection in OSD.
6.3.2. Arrow Key Channel Shift Function
Press <Scroll Lock> twice, and press <Left Arrow> or <Right Arrow> key to shift left/right one channel.
Switch to left one channel
<Scroll Lock> →<Scroll Lock>→<Left Arrow>
Switch to right one channel
<Scroll Lock> →<Scroll Lock>→<Right Arrow>
6.3.3. <ALT> Channel Shift Function
1.Start <ALT> Channel shift Function
< ALT > channel shift function default was off. You can press Hot-Key <Scroll Lock> twice, <ALT> and then press
<Enter> to turn on or turn off this function alternately.
2.Shift the channel by <ALT> key
Press left < ALT > or right < ALT > key twice, the PC channel will automatically shift to left or right one channel
(channel decrease / increase to next) when < ALT > channel shift function is enabled.
Enable/Disable <ALT> channel shift function
<Scroll Lock> →<Scroll Lock>→< ALT >→<Enter>
Switch to left one channel
<Left ALT> →< Left ALT >
Switch to right one channel
<Right ALT> →< Right ALT >
6.4. Channel Select - Cascade Chain Layer
You can select the active channel directly under cascade chain connection.
The following hot key sequence is used for quick channel selection.
Press <Scroll Lock> twice, <D>, the cascade channel number (1,2,3……16), and Press <Enter>.
Channel select to first layer
< Scroll Lock > →< Scroll Lock >→<D>→< CH-L1 >→< Enter >
Channel select to second layer
< Scroll Lock > →< Scroll Lock >→ <D>→< CH- L1 >
→ <D>→< CH-L2 >→< Enter >
Channel select to third layer
< Scroll Lock > →< Scroll Lock >→<D>→<CH-L1 >
→<D>→< CH-L2 >
→<D>→< CH-L3 >→< Enter >
•
•
•
•
•
•
•
•