Novak Pit Wizard - Manual (Page 21)

21 PIT WIZARD INSTRUCTION MANUAL
DOWNLOADING PARAMETERS
TO CYCLONE
This section outlines the steps that will allow you to download the
parameters that are currently displayed in the Pit Wizard’s Edit
Profile mode into the Cyclone speed control’s Profile 4. The down-
loaded Profile will always be the active Profile in the Cyclone even
if this is the first time Profile 4 has been activated. You will now
have the original three Profiles that came with the Cyclone, plus
the user-programmable Profile (Profile 4) to choose from through
the One-Touch button. Refer to your Cyclone Owner’s Manual for
instructions on selecting Profiles with the One-Touch button.
IMPORTANT NOTE: You must upload Profile 1, 2, or 3 from your
Cyclone to get the values for Neutral, Full Throttle, and Full Brake
for any new Profile to be downloaded. These values can NOT be
re-programmed through the Cyclone’s One-Touch Set-Up. If the
One-Touch settings from your Cyclone are not used for Profile 4,
your speed control will not be properly adjusted to your transmitter.
1. Turn on your transmitter, then turn on your speed control.
2. Turn on the Pit Wizard’s power switch––Slide to ON position.
3. Connect the Pit Wizard’s D•LINK harness to your Cyclone’s
DataLink socket located on the top of the speed control. The
D•LINK connector will only clear the transistors of the speed
control if the “D•LINK” lettering is right side up (Figure 10). If
you have external heat sinks installed, be sure that they do not
extend beyond the front edge of the transistors, as they may
have to be repositioned to gain access to the connector.
Note: The motor will be disabled as soon as the Pit Wizard is connected.
You can use a DSC cord to disable the transmitter’s RF section (For
use at a track/in the pits to avoid interference).
**At this time the Cyclone’s LED should be illuminated solid red.