TechniSat TechniCorder ISIO STC - Manual (Page 15)

15
Also see section 8.6 (DVB-S antenna setting) in your operating manual.
It is not possible to receive analogue TV via the cable or antenna!
4.2.3.1 Simultaneous operation with DVB-C/T antenna signals
Use the TechniSat DVB C/T switch to receive DVB-T signals, DVB-C and DVB-C cable
channels simultaneously (item no. 0000/3263). This switch automatically switches between
DVB-T reception and reception of DVB-C cable channels, thus preventing potentially con-
flicting frequency influences. For this purpose, connect the switch output as described
in section 4.2.3.
4.2.4 Operating with a rotating system
b For operation with a rotating system, connect the DiSEqC motor (Level 1.2) to LNB
input 1 .
4.3 Connecting to a TV
d Connect the receiver (HDMI output) and TV (HDMI input) via an HDMI cable.
If your TV is equipped appropriately, it will automatically switch to the HDMI input when
the digital receiver is switched on.
Alternatively:
Connect the receiver (SCART socket) and TV (SCART socket) using a SCART cable.
If your TV is equipped appropriately, it will automatically switch to the AV and thus to
SAT operation when the digital receiver is switched on. It may be necessary to adjust
the signal type on your TV, see section 8.3.6 in your operating manual.
4.4 Hi-fi / surround sound amplifier
To achieve the best possible sound quality, you can connect your digital receiver to a hi-fi /
surround sound amplifier.
4.4.1 Digital
e If your amplifier is equipped with a suitable electrical or optical input, you should con-
nect the AUDIO OUT DIGITAL socket electrically or optically with the elec-
trical or optical input on your amplifier.
Depending on the signal provided by each broadcaster, sampling rates of 32, 44.1 and
48 kHz are available. In addition, where broadcast, the Dolby Digital signal is also
available on this output.
4.4.2 Analogue
e To do this, use a suitable cable to connect the cinch sockets Audio R and Audio L
on the digital receivers to an input on your hi-fi amplifier.
(e.g. CD or AUX; please note that the phono input is not suitable!)