TechniSat TechniCorder ISIO STC - Manual (Page 6)

6
2 Please read this first
Before connecting and using the device, first check that everything has been supplied
and familiarise yourself with the safety instructions.
The delivery includes:
1 digital receiver, 1 Quick Start Manual, 1 CD-ROM,
1 remote control, 1 mains cable, batteries (2 x 1.5V microcells)
2.1 Safety advice
For your own protection you should read the safety precautions carefully before using your
new receiver.
The manufacturer accepts no liability for damage caused by inappropriate handling, or by
non-compliance with the safety precautions.
Function-related discharge current may occur with electrical equipment. This
is acceptable and poses no risk, even if it is experienced as a slight tingling.
To prevent these discharge currents, mains operated devices (receivers, TVs etc.)
must always be installed or connected with the power switched off, i.e. devices must
be disconnected from the mains power supply.
-
Only operate the receiver in a temperate climate.
- To ensure adequate ventilation, place the receiver on a flat, horizontal surface and
do not place any objects on top of it. There are ventilation slots here to allow heat to
be dissipated from the interior of the unit.
- Never place any burning objects, such as lit candles, on top of the unit.
- Do not expose the receiver to water droplets or water spray, and do not place any
objects filled with liquid, such as vases, on top of it. If water gets into the unit, imme-
diately disconnect the mains plug and inform the service department.
- Do not operate any sources of heat near to the unit which may also heat it up.
- Do not obstruct the ventilation slots.