TechniSat TechniCorder ISIO STC - Manual (Page 56)

56
Fault Possible cause Solution
Receiver cannot be
operated, switched on or off
Defective data stream -->
receiver blocked
Hold down the On/Stand-by
button on the receiver or the
remote control for approx.
5 seconds.
Pull the mains plug out
of the power supply for
approx. 5 seconds and then
switch the deviceback on
Perform a Flash reset:
Warning!
All personal settings will be
lost.
> Remove the mains adap-
ter from the device
> Press and hold
Standby and the up
arrow key at the same
time.
> With Standby and
the up arrow key
depressed , reconnect
the plug
> Keep the buttons
pressed for around
5 seconds and then
release both buttons.
The text “Factory set-
tings ” appears in the
display.
USB device not recognised USB device formatted for
wrong file system
Format USB device for
FAT32 file format
Device automatically
switches off after a certain
time
Auto Standby function is
activated
Auto Standby setting-check
and deactivateif necessary.
(section 8.2.7)