TechniSat TechniCorder ISIO STC - Manual (Page 29)

29
During this step, a channel spectrum is displayed with the channel signal levels. Using this
spectrum, you can align your DVB-T antenna to achieve optimum reception.
If the DVB-T source has been disabled, as described in the step “Selecting recep-
tion signals ”, the next available page of the installation wizard will appear instead of
this page.
> Use the up/down arrow keys to highlight the Antenna supply field and open
the selection window by pressing the OK button.
> Switch the antenna feed on or off by using the up/down arrow keys to highlight
the relevant input and confirm with the OK button.
> To move onto the next step of the installation, use the arrow keys to highlight the
Accept field and confirm by pressing the OK button.
The display is dependent on your tuner configuration. Also see section 3.2 (Using an
optional tuner module).
Network configuration
In this step the TV automatically checks the network configuration.
> If you do not want to run the network configuration check, press the Info button.
> If you wish to check or change the network settings, press the Options key.