TechniSat TechniCorder ISIO STC - Manual (Page 31)

31
arrow keys to highlight the All channels or All unencrypted channels
and then start the channel search process by pressing the OK button.
In this search, all selected satellites in the antenna configuration are automatically
scanned for channels. This procedure may take several minutes. Please note all
messages displayed on screen.
After a channel list update or a satellite search is performed, a search is performed
for all other activated reception types. This procedure may also take several minutes.
Please note all messages displayed on screen.
If you skip the channel search/channel list update, the default channel list will be
loaded.
Regional programmes
Some broadcasters transmit channels with varying regional content. On this page you can
define your preferences for these regional programmes. The selected regional programme is
automatically set by switching to the relevant programme provider.
> Use the arrow keys to highlight the programme provider you would like to specify
for your preferred regional channel.
> Press the OK button to open a window with the regional programming available for
this programme provider.
> Use the up/down arrow buttons to select your preferred regional programming.
> Press the OK button to close the window again.
> To accept the selected regional programming, use the arrow keys to highlight the
Accept field.
> Confirming with the OK button takes you to the next installation step.
If you subsequently select another regional programme for a programme provider as
per section 9.4.4 in your operating manual, this will be saved in the same way in
future for this programme provider.