TechniSat TechniCorder ISIO STC - Manual (Page 46)

46
13 DVR playback
You can access DVR recordings via the DVR Navigator.
13.1 Calling up the DVR Navigator / Starting DVR playback
The DVR Navigator can be called up in the following ways. Dependent upon whether you
are currently in TV or radio mode, a list will appear of the existing TV or radio recordings
stored on the internal hard drive, a connected USB storage device, an inserted SD/MMC
card or an available network drive.
When doing so pay careful attention to the information and settings for global
and user-dependent parental control in section 16.2 of the instruction manual.
The broadcast information can be displayed and hidden by pressing the Info button
repeatedly.
> You can start to play back a recording by highlighting it and confirming with OK.
13.2 When in TV mode
> In TV mode press the Stop / DVR button to switch directly to the DVR Navigator.
or
>
Open the programme lists navigator by pressing the OK button and switch to the
DVR Navigator by pressing the Stop/DVR button.
or
> In
Function selection , now select the Films/DVR item.
> Now call up the My Recordings folder on your attached recording medium (sec-
tion 11.4.1 in your instruction manual).
13.4 From playback of a running / existing DVR recording
> Press the OK button to open the DVR Navigator.
or
> In
Function selection , now select the Films/DVR item.
> Now call up the My Recordings folder on your attached recording medium (sec-
tion 11.4.1 in your instruction manual).