Toa VM-3000 Series - Manual (Page 19)

6.4. External ATT Settings
19
Available Settings Not used (default), All output, Each output
Setting this to “All output” causes the
speaker lines to be displayed as shown
at right.
Notes
• This function can be used only when all the versions of VM-3000VA firmware, VM-3000E firmware, and
VM-3000 Setting Software are 2.00 or later.
• Both of external attenuators and the EOL unit (refer to page 21) cannot be used together in the same
system.
Set whether or not an external attenuator is being used.