VACUUBRAND DCP 3000 - Manual (Page 13)

page 13 of 64
General information
To operate the vacuum gauge DCP 3000, at least one
external pressure transducer (VSK 3000 or VSP 3000 or
MPT 100) is required!
Remove all packing material from the packing box. Re-
move the product from its packing-box and retain all pack-
aging until the equipment is inspected and tested. Inspect
the equipment promptly and carefully.
If the equipment is damaged, notify the supplier and the
carrier in writing within three days. Retain all packing ma-
terial for inspection. State the item number of the product
together with the order number and the supplier’s invoice
number. Failure to check and give notice of damage will
void any and all warranty claims for those deficiencies.
Store the equipment in dry and non-corrosive conditions
(see also “Technical data”, pg. 21) if the equipment is
not used immediately.
+
Do not use any damaged equipment.
Intended use
+
Ensure that the individual components are only con-
nected, combined and operated according to their de-
sign and as indicated in the instructions for use. Use
only original manufacturer’s spare parts and ac-
cessories. Otherwise the safety and performance of
the equipment, as well as the electromagnetic compat-
ibility of the equipment might be reduced.
The CE mark or the cTÜVus mark may be voided if not
using original manufacturer’s spare parts.
+
Comply with all notes on correct vacuum and electri-
cal connections; see section “Use and operation”, pg.
25.
NOTICE