VACUUBRAND DCP 3000 - Manual (Page 17)

page 17 of 64
Safety during operation
➨
Adopt suitable measures to prevent the release of
dangerous, toxic, explosive, corrosive, noxious or pol-
luting fluids, vapors and gases.
+
Never operate this vacuum gauge if it has a damaged
cord or plug. If the vacuum gauge is not working prop-
erly, has been dropped or has fallen into water, contact
your service provider.
+
Prevent any part of the human body from coming into
contact with vacuum.
Operation with pressure transducer VSK 3000:
+
Attention: At pressures above approximately 795 Torr
(1060 mbar) the pressure reading becomes incorrect
due to saturation of the pressure transducer. The dis-
play flashes. Release pressure immediately! Risk of
bursting!
Operation with pressure transducer VSP 3000:
+
Attention: Maximum pressure reading: 7.5*10 2 Torr
(1*10 3 mbar). Pressure values above 7.5*10 2 Torr
(1*10 3 mbar) can not be displayed. Danger of unno-
ticed overpressure! Risk of bursting!
Operation with pressure transducer MPT 100:
+
See instructions for use of MPT 100.
Electronic equipment is never 100% fail-safe. This may
lead to an ill-defined status of the equipment or of other
connected devices. Provide appropriate protective mea-
sures to allow for the possibility of failure and malfunction.
The protective measures must also allow for the require-
ments of the respective application.
NOTICE