Vexilar CLC-200 - Manual (Page 10)

10
UNIT ASSEMBLY
(Portable Version)
Remove the gimbal knobs from the unit and then
remove the rubber washers from the knobs. Set the battery
pack down on a table top and place the unit, face down,
inside with the top of the unit opposite the battery pack
handle. Place one gimbal knob on each side of the unit.
Place the metal ends of the carry strap over each knob with
the bend pointing outward, away from the threads. Put a
flat rubber washer onto each of the threaded shafts to hold
the strap ends in place. Install the knobs into the unit,
through the battery pack. Tighten both slightly.
INSTALLING THE
BATTERIES
Turn the unit over to
access the battery compart-
ment door (figure 11).
Unscrew the two retaining
screws and remove the com-
partment door. Install eight
AA
ALKALINE
batteries (not
included) by following the
imprinted guides in the battery compartment. Replace the
compartment door and tighten the screws back into place.
Plug the power cord from the battery pack into the
CLC-200 and tighten snugly.
Note— The battery compartment is not sealed. After use in a wet
environment, remove the batteries and leave the compartment open.
This allows it to dry and minimize any corrosion that may develop.
Figure 11