Vexilar CLC-200 - Manual (Page 5)

5
your base directly over the hole
using the hole cover spacer
gasket. Be sure to run cables out
the back side of the spacer
gasket which has the pre-cut
groove. (See figure 5 )
Now mark the center of each
of the four holes with a fine point
marker or center punch. Pre-drill
the mounting holes using a 1/8" drill bit and use the
supplied mounting screws. DO NOT OVERTIGHTEN THE
SCREWS.
When reattaching the ProMount platform (unit attached)
to the mounted base, slide it back into position until you
hear a loud“click”. This confirms it is locked into place.
IN-DASH MOUNTING
The CLC-200 can be mounted in
the dash of your boat using the
optional In-Dash Mounting Kit (part#
IDK001). This kit will contain the
necessary hardware and instructions
to complete the installation.
CONNECTING POWER
Plug the 2 pin connector into the back of the unit. Find
the closest source of 12 volts and route the cord to it. Keep
the cord away from sharp metal edges and avoid tight
places where the cord may get crushed. Connect the white
Figure 5
CLC-200 In-Dash
Kit #IDK001