Vexilar CLC-200 - Manual (Page 6)

wire to positive and the black wire to negative. If the cord
provided is not long enough, more can be added. Use 18
gauge wire minimum. Install the included 1 amp in-line
fuse, placed in the positive line, as close to the power source
as possible, to protect against shorts in the wiring.
ASSEMBLING THE TRANSOM STYLE
TRANSDUCER
Locate the transducer, and bracket hardware. This
includes;
1 - Transducer
2 - Angle Brackets
4 - Bracket Screws
2 - Bracket Plates
4 - Nuts
4 - Mounting Screws
Attach the bracket to the transducer as shown in Figure
7. The flanges of the bracket normally point outward, away
from the transducer. If mounting space is tight, you can
reverse the angle brackets and face the flanges inward.
TRANSOM TRANSDUCER INSTALLATION
When choosing an area to mount the transducer, keep
in mind that you need clear water flow across the face of
the transducer to insure a clear reading at all speeds. Try
to stay away from rivets, ribs, or strakes that would be just
in front of the transducer. They can disturb the water and
scramble the reading.
6