Vexilar CLC-200 - Manual (Page 9)

the same size as
the transducer,
on the inside of
the hull. Place
the transducer in
the glue and
press it down
firmly,
gently
twisting it back and forth, making sure that there are no air
bubbles in the glue between the transducer and the hull. It
is important that you let the glue dry completely before
turning the unit on.
* If your hull is aluminum, use silicone. This material will flex with
the hull at high speeds and in rough water.
9
OPTIONAL TEMPERATURE SENSOR
To install the optional temperature sensor (part# TP0002)
use the supplied mounting screws to secure the probe to
boat transom. Alternately, you can use a plastic cable tie or
wire twist tie to secure it to existing hardware. The probe
should be in the water, but not below the hull line.
Route the cable up to the unit just as you ran the
transducer cable. Remove the plastic protective cap from
the temperature sensor jack on the back of the unit. Be sure
to keep it for future use. Plug the 8
pin connector into the CLC-200.
When you turn the unit on, the
temperature reading will appear on
the screen automatically.
TP0002