Vexilar CLC-200 - Manual (Page 4)

4
UNIT ASSEMBLY
(Gimbal Version)
You will need to
find a place to mount
the CLC-200 that will
make it easy to view
and reach. You must
provide the unit with
power and mount the
transducer in an effective location.
MOUNTING THE UNIT
Attach the CLC-200 to the ProMount
™
bracket system.
First, remove the platform by lifting the tab and pulling it
forward, as in figure 4. Use the supplied hardware with
locking washers to securely attach your unit to the remov-
able platform section. Be sure you mount the unit to the
ProMount
™
platform so that the “lift” tab is facing forward.
You are now ready to locate the permanent base. First
look for a flat area for mounting. If you are going to drill
holes in your dash or deck to run cables, make sure you
spend a little time to place the holes in the right spot before
beginning. Allow for
plenty of movement
for your electronics
and cables. If you are
drilling a large hole
to accommodate the
cable connectors, you
may want to position
Lift
Pull
Figure 4