Vexilar CLC-200 - Manual (Page 11)

ASSEMBLING THE TRANSDUCER
Locate the transducer and bracket assembly. This
includes:
1 - Transducer
1 - Metal Bracket
1 - Suction Cup
1 - Short Panhead Screw
2 - Short Machine Screws
2 - Nuts
2 - Washers
1 - Safety rope
The suction cup installs using the single short screw.
Attach it to the hole in the flat bracket as shown in figure
12. Now locate the transducer and the remaining hardware.
Install the transducer onto the bracket as shown. Install the
two short screws through the transducer slots and into the
bracket holes. Place the washers and then the nuts onto the
screws and tighten
securely.
Finally,
install the safety rope.
Tie a knot in the rope
and run it through
the upper hole in the
bracket until the knot
stops at the hole. You
will tie the other end
to the boat.
11
Figure 12