Winco DSE3000 Series - Manual (Page 10)

DSE Model 3000 Series Control and Instrumentation System Operators Manual
10 Part No. 057-086 3000 Series OPERATING MANUAL ISSUE 4 03/12/2009 ADM
3.8 DIMENSIONS AND MOUNTING
3.8.1 DIMENSIONS
99mm x 79 mm x 40mm (3.9“ x 3.1“ x 1.6”)
3.8.2 PANEL CUTOUT
80mm x 68mm (3.2“ x 2.7“)
3.8.3 WEIGHT
89g (0.089kg)
3.8.4 FIXING CLIPS
The module is held into the panel fascia using the supplied fixing clips.
•
Withdraw the fixing clip screw (turn anticlockwise) until only the pointed end is protruding from the clip.
•
Insert the three ‘prongs’ of the fixing clip into the slots in the side of the 3000 series module case.
•
Pull the fixing clip backwards (towards the back of the module) ensuring all three prongs of the clip are
inside their allotted slots.
•
Turn the fixing clip screws clockwise until they make contact with the panel fascia.
•
Turn the screws a little more to secure the module into the panel fascia. Care should be taken not to over
tighten the fixing clip screws.
NOTE:- In conditions of excessive vibration, mount the panel on suitable anti-vibration mountings.
3.8.5 OPTIONAL SILICON SEALING GASKET
The optional silicon gasket provides improved sealing between the 3000 series module and the panel fascia.
The gasket is fitted to the module before installation into the panel fascia.
Take care to ensure the gasket is correctly fitted to the module to maintain the integrity of the seal.
Fixing clip fitted to
module
Fixing clip
Gasket fitted to
module
Sealing gasket