Winco DSE3000 Series - Manual (Page 23)

DSE Model 3000 Series Control & Instrumentation System Operators Manual
Part No. 057-086 3000 Series OPERATING MANUAL ISSUE 4 03/12/2009 ADM 23
6.2.3 ENGINE RUNNING
In manual mode, the load is not transferred to the generator unless a ‘loading request’ is made.
A loading request can come from a number of sources.
•
Activation of an auxiliary input that has been configured to remote start on load
•
Activation of the inbuilt exercise scheduler if configured for ‘on load’ runs.
NOTE:-The load transfer signal remains inactive until the Oil Pressure has risen. This prevents
excessive wear on the engine.
Once the load has been transferred to the generator, it will not be automatically removed. To manually transfer the
load back to the mains either:
•
Press the auto mode button to return to automatic mode. The set will observe all auto mode start
requests and stopping timers before beginning the Auto mode stopping sequence.
•
•
Press the stop button
•
De-activation of an auxiliary input that has been configured to remote start on load
6.2.4 STOPPING SEQUENCE
In manual mode the set will continue to run until either :
•
The stop button is pressed – The set will immediately stop
•
The auto button is pressed. The set will observe all auto mode start requests and stopping timers
before beginning the Auto mode stopping sequence.