Winco DSE3000 Series - Manual (Page 14)

DSE Model 3000 Series Control and Instrumentation System Operators Manual
14 Part No. 057-086 3000 Series OPERATING MANUAL ISSUE 4 03/12/2009 ADM
4.2.4 CAN AND DIGITAL INPUTS (MODEL 3110-XX-02)
Model 3110-xx-020 (Can enabled module) only.
NOTE:- Magnetic Pickup interface is not fitted to the 3110-xx-02 module
PIN
No
DESCRIPTION CABLE
SIZE
NOTES
10 CAN port L
0.5mm²
AWG 20
Use only 120
Ω
CAN approved cable
11 CAN port H
0.5mm²
AWG 20
Use only 120
Ω
CAN approved cable
12 Configurable digital input A
0.5mm²
AWG 20
Switch to negative
13 Configurable digital input B
0.5mm²
AWG 20
Switch to negative
14 Configurable digital input C
0.5mm²
AWG 20
Switch to negative
15 Configurable digital input D
0.5mm²
AWG 20
Switch to negative
16 Configurable digital input E
0.5mm²
AWG 20
Switch to negative
17 Configurable digital input F
0.5mm²
AWG 20
Switch to negative
NOTE:- Screened 120
Ω Ω Ω Ω
impedance cable specified for use with CAN must be used for the CAN link and
the Multiset comms link.
DSE stock and supply Belden cable 9841 which is a high quality 120
Ω Ω Ω Ω
impedance cable suitable for CAN
use (DSE part number 016-030)
4.2.5 PC CONFIGURATION INTERFACE CONNECTOR
DESCRIPTION CABLE
SIZE
NOTES
Socket for connection to PC with DSE
Configuration Suite PC software. 0.5mm²
AWG 20
This is a standard USB type A to
type B cable.
NOTE:- The USB connection cable between the PC and the 3000 series module must not be extended
beyond 5m (5yds). For distances over 5m, it is possible to use a third party USB extender. Typically, they
extend USB up to 50m (yds). The supply and support of this type of equipment is outside the scope of
Deep Sea Electronics PLC.
CAUTION!: Care must be taken not to overload the PCs USB system by connecting more than the
recommended number of USB devices to the PC. For further information, consult your PC supplier.
CAUTION!: This socket must not be used for any other purpose.
This configuration cable is
the same as normally used
between a PC and a USB
printer.