Sears KENMORE 11682 - Manual (Page 27)

SECTION 3. LEARN THE STITCHES
• Sew a Button
Set the Machine
Stitch Stitch selector
.L
nilUlla
Top thread tension Stitch length control
control 1 to 4 any number (not
necessary to adjust)
Zigzag foot
■|i
Darning plate
Use the darning plate for button sewing (see p. 18).
I
1 . Set the stitch selector at'
2 .
CIO •
Align the both holes of the button with the slot of the foot and place the left
hole of the button just below the needle point.
Lower the foot and turn the stitch selector to zigzag until the needle point
comes just above the right hole of the button.
Sew about five stitches and raise needle.
/
t
V . ___ - - -............................. /
To strengthen the shank, cut the
threads leaving a 20 cm ( 8 ") tail. Bring
the needle thread down through the
hole in the button and wind it around
the shank.
Draw die thread to the bottom side
and knot.
23