Sears KENMORE 11682 User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 4. PERFORMANCE PROBLEMS CHART
What to Do When
PROBLEM
PROBABLE CAUSE
CORRECTION
Irregular Stitches
Incorrect size needle.
Improper threading.
Loose upper thread tension.
Pulling fabric.
Loose presser foot.
Unevenly wound bobbin.
Nicks or burrs at hole of needle plate.
Choose correct size needle for thread and fabric.
Rethread machine.
Tighten upper thread tension.
Do not pull fabric; guide it gently.
Reset presser foot.
Rewind bobbin.
Replace needle plate, or polish off burrs completely.
Breaking Needle
Pulling fabric.
Incorrect size needie.
Incorrect setting of needle.
Loose presser foot.
Do not pull fabric; guide it gently.
Choose correct size needle for thread and fabric.
Reset needle,
Reset presser foot.
Bunching of Thread
Upper and lower threads not drawn back
under presser foot before starting seam.
When starting a seam be sure to draw both threads under and
back of presser foot about 4" and hold until a few stitchs are
formed.
Puckering
Incorrect thread tension(s).
Using two different sizes or kinds of thread.
Bent or blunt needie.
Loose presser foot.
Fabric very sheer or very soft.
Reset thread tension(s).
Upper thread and bobbin thread should be same size and kind.
Insert new needle.
Reset presser foot.
Use underlay of tissue paper.
34