Sections. care for your machine – Sears KENMORE 11682 User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTIONS. CARE FOR YOUR MACHINE
• Clean the Shuttle Race
This area must be kept free of dust, lint and occasional tangled thread. Clean the shuttle race area
about every three months.
Center pin of
the shuttle
Lever
Shuttle driver
Lever
Shuttle Race
(Oil here)
Shuttle Race
Cover
To Clean the 9iuttle Area:
1.
Raise the needle bar to its highest
point and remove the bobbin case.
2. Piich
atiria
sftuttie I'aBi^B
3. Glean the shuttle race with a lint
brush.
4.
Put a drop of oil on the center pin of
the shuttle and shuttle race. Do not
over-oil.
To Replace Shuttle Assembly:
1. Position shuttle race as illustrated so that shuttle
driver is forming half moon on the left side of the
machine.
shunte by center pin pffitttm shuttle sipts^
to form a half moon on the right side. Pointed hook
will be on the bottom.
3.
4.
Place shuttle race cover into place over shuttle
assembly.
Snap the levers back into the original position.
37