Section 3. learn the stitches sew in a zipper, Is 1 - b – Sears KENMORE 11682 User Manual
Page 34
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 3. LEARN THE STITCHES
Sew in a Zipper
Fabric Preparation:
Put the right sides of the fabric to
gether and sew to the end of the zip
per opening. Use the reverse to lock
the stitches.
Sew the zipper opening with stitch
length at "4" and top thread tension
at "3".
Set the Machine
Stitch
Stitch selector
Top thread tension
control 3 to 6
«
Stitch length
control 2
IS
1 -
B
3
Zipper teeth
Fold back the left seam allowance
as shown.
2.
Turn under the right seam allow
ance to form a 1/8" fold,
3.
Place the zipper teeth next to the
1/8" fold and pin in place.
6
.
To sew the left side of the zipper,
set the zipper foot on the left side
of the needle.
Lower the zipper foot on the right
side at the bottom of the zipper
so that the needle pierces the fold
and the zipper tape.
Sew through the fold and the zip
per tape to the point where the
slider begins.
Lower the needle to hold the fab
ric and raise the presser foot.
30