SINGER W714 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
19
BUTTONHOLES
Buttonholes of various lengths can be made by just
turning the buttonhole control knob.
To
establish
the
correct
length
buttonhole
required
add
^/8
inch to the cutting space for bar tacks.
To obtain the length of the cutting space, the opening
through which the button passes is measured by adding
the width "A" and thickness "B" of the button (Fig. 31 A).
First mark the beginning and end of the buttonhole on
the fabric with a basting line or tailor's chalk. Make one
or
two
buttonholes
on
scrap
fabric
(following
directions
below) to be sure the machines adjustments are correct.
(1) Set pattern selector lever (Fig. 24C) at M.
(2) Set needle positon lever (Fig. 24B) at L.
(3)
Replace presser foot with special purpose buttonhole
foot.
It
provides
maximum
visibility
and
allows
closely spaced stitches to feed evenly (Fig. 30).
(4) Set stitch length knob 12 (Fig. 1) as near 0 as
possible without stopping the feeding action.
(5) Set buttonhole control knob (Fig. 33) at 0 and
then to the first buttonhole setting, number
1
.
This will set the width of the buttonhole sides.
Lower needle carefully into the mark on the
fabric indicating the start of the buttonhole.
Lower presser foot and sew full length of left
hand side of the buttonhole (Fig. 32, Step 1).
(
6
)
Fig. 30
s i
ii
p ^
T? '
Ei'
Pi
V
Fig. 32